User Manual Q&AAnswer
Jan 17, 2025 - 12:13 AM
To enable or disable the boost converter, you can use the EN pin. When the EN pin is set to a logic-high voltage (above the threshold voltage), the boost converter starts operating. Conversely, when the EN pin is set to a logic-low voltage, the boost converter is shut down.
To enable the boost converter, connect the EN pin to a voltage higher than the logic-high threshold voltage specified in the datasheet. This will activate the circuit and allow it to operate.
To disable the boost converter, connect the EN pin to a logic-low voltage. This will turn off the circuit and stop it from operating.
It is important to note that leaving the EN pin floating (unconnected) is not recommended. Always connect the EN pin to either a logic-high or logic-low voltage to ensure proper operation of the boost converter.
Add New Comment