User Manual Q&AAnswer
Jan 16, 2025 - 10:42 PM
To install the Trail ARMOR TAUBMS-PR800 Polaris Ranger 700 or 800 Under Bed Mud Shield, please follow the instructions provided below:
1. For easier access, remove the pin from the hydraulic cylinder bed lift. Tilt the bed back against the tires.
2. Remove the factory screws that secure the bedside lip to the bottom of the bed. Retain these screws as you will reuse them.
3. Hold one side's bed panel in place and secure it using the removed factory screws along the outer edge of the panel.
4. Secure the black 10 x % into the panel as shown in Picture 1.
5. Secure the remainder of the panel using the Trail Armor supplied fasteners in the inner and upper holes. The locations are shown in Picture 1.
6. Repeat the above steps for the other side of the bed.
7. Replace the factory pin on the hydraulic cylinder bed lift and close the bed.
Please note that this product was designed, fit, and tested on new vehicle specifications. Any damage, modifications, or excessive wear to your vehicle may require modification to the product and/or your vehicle to ensure proper fitment.
If you have any further questions or need assistance, you can contact Trail Armor at 662-233-5700 or visit their website at www.trailarmor.com.
Add New Comment