User Manual Q&AAnswer
Jan 16, 2025 - 09:39 PM
To install the ACCESS LIGHTING 20135LEDDMG 8 Inch Black Outdoor Wall Sconce, please follow these step-by-step instructions:
1. Before starting the installation, disconnect the power by turning off the circuit breaker or removing the fuse at the fuse box. Simply turning off the light switch is not sufficient to prevent electrical shock.
2. Prepare the fixture by removing any existing fixture and exposing the supply wires from the J-box. Secure the mounting bracket to the J-box using the supplied screws.
3. Make wire connections by connecting the black supply wire to the black fixture wire and securing them with the supplied wire nuts. Connect the white supply wire to the white fixture wire and secure with wire nuts as well. Attach the green J-Box wire around the green hexagonal head xxxx or connect it to the green supply grounding wire of the fixture. Secure all wires with electrical tape (not supplied) and carefully tuck them into the J-Box.
4. Mount the fixture to the mounting bracket by aligning it over the bracket and securing it with the supplied screws. Note that this fixture is wet location rated, so it is recommended to use clear caulking to seal the space between the fixture mounting bracket and the wall to prevent moisture from entering the outlet box. Leave a space at the bottom to allow for the escape of moisture. It is recommended to use Outdoor Silicon Sealant for this purpose.
5. Restore the electricity by turning on the circuit breaker or replacing the fuse, and then check the operation of your new ACCESS LIGHTING fixture.
Important Safety Instructions:
- Consult a qualified electrician to ensure correct branch circuit conductor.
- This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
- Read all instructions and do not install the fixture in hazardous locations.
- Do not install the fixture assembly closer than 6 inches from any curtain or similar combustible material.
- If the fixture is to be removed or replaced, ensure that the electricity is switched off and that the fitting is cool before touching it.
Please refer to the provided instruction manual for additional details and illustrations.
Add New Comment