User Manual Q&AAnswer
Jan 16, 2025 - 09:29 PM
To ensure the stability and safety of the Evergreen 1510135 Wardrobe Storage Cabinet, it is important to properly secure it to the wall. Here are the steps to follow:
1. Identify the location where you want to install the wardrobe cabinet. Make sure it is on a flat-level surface.
2. Locate the wooden wall studs in the area where you plan to install the cabinet. It is recommended to secure the cabinet to the studs for maximum stability.
3. Use a stud finder or tap on the wall to locate the studs. Mark the center of the studs with a pencil.
4. Position the wardrobe cabinet against the wall, aligning it with the marked stud locations.
5. Take the provided anchoring screws and drive them through the pre-drilled holes in the back of the cabinet and into the center of the wall studs. Use a Phillips-head screwdriver to tighten the screws securely.
6. If you are unable to access reliable wall studs, use the provided hollow wall anchors instead. Follow the instructions included with the hollow wall anchors to properly install them into the wall. Then, secure the cabinet to the anchors using the same anchoring screws.
7. Before drilling or inserting screws, ensure there are no hidden electrical wires or other obstacles in the intended anchoring location.
By following these steps and properly securing the Evergreen 1510135 Wardrobe Storage Cabinet to the wall, you can ensure its stability and minimize the risk of injury or damage.
Add New Comment