User Manual Q&AAnswer
Jan 16, 2025 - 09:07 PM
To start the AL-KO MH 5065 R Petrol Tiller Cultivator, follow these steps:
1. Before starting the machine, make sure to read the operating instructions delivered by the engine producer for the petrol engine.
2. Set up the handle height according to your proper body size. Common setting-up of height corresponds to haunch height. Loose the screws on the cover support, set up the handle height according to the long holes, and then tighten the screws.
3. If you need to transport the machine to a different location, you can use the transport wheel. If you are operating the machine, remove the transport wheel or fix it into the upper grip.
4. Set the saturator lever into the "START" position.
5. Pull out the starter cable quickly and then let it slowly wind up.
6. To put the weedier share into operation, pull up the clutch lever entirely and hold it. The weedier share will begin to rotate only at the second half of the lever motion.
7. To stop the weedier share, release the clutch lever.
8. To start the reverse drive, pull up the lever for reverse drive as far as it will go.
9. To disconnect the reverse drive, release the lever for reverse drive.
10. To switch off the motor, set the saturator lever into the "STOP" position.
Please note that these instructions are a summary and it is important to refer to the original operating instructions for more detailed information and safety precautions.
Add New Comment