User Manual Q&AAnswer
Jan 16, 2025 - 05:42 AM
To install the DYNOJET P171689 Power Commander V Controller, follow these steps:
1. Remove the seat and the battery to access the bolts for removing the side covers.
2. Remove the side covers.
3. Remove the fuel tank.
4. Place the Power Commander V (PCV) in the tail section and route the harness down the right side of the frame towards the throttle bodies.
5. Locate the Throttle Position sensor connector (a black 6-pin connector on the right side of the throttle bodies) and unplug it.
6. Plug the PCV in line with the stock harness and TPS.
7. Route the PCV harness with the 10-pin connectors under the throttle bodies over to the left side of the engine.
8. Remove the 3 bolts securing the coolant reserve bottle in place.
9. Unplug the Crank Position Sensor (CPS) connector (a 10-pin connector on the left side of the engine, above the shift shaft).
10. Plug the PCV harness in line with the stock wiring harness and CPS.
11. Reinstall the coolant reserve bottle.
12. Unplug the stock wiring harness from each injector.
13. Plug the PCV harness in line with the stock wiring harness and injectors. The PCV orange wires are for cylinder #1 (left), yellow wires for cylinder #2, and green wires for cylinder #3 (right).
14. Reinstall the side covers and battery.
15. Secure the PCV to the top of the battery using the supplied Velcro. Clean the surface before attaching using the alcohol swab.
16. Attach the ground wire of the PCV to the negative side of the battery.
17. Reinstall the fuel tank and bodywork.
You can download the latest map files for the DYNOJET P171689 Power Commander V Controller from the Dynojet website at dynojet.com/tunes.
Please refer to the DYNOJET P171689 Power Commander V Controller Installation Guide for more detailed instructions and illustrations.
Add New Comment