User Manual Q&AAnswer
Jan 16, 2025 - 05:12 AM
To wire the LOCKLY PGI303 Smart Access Control + Video Doorbell, follow these steps:
1. Identify the different ports on the device:
- PUSH Lock Control Port
- LOCKLY NC Door Open Detection Port
- BUTTON-SW Door Exit Button Port +
- GND1 Door Exit Button Port -
- BELL-SW Doorbell Button Port +
- BELL Doorbell Signal Port
- GND2 Access Control Power -
- DC12V Access Control Power +
2. Refer to the Wiring Diagram provided in the manual (Section 2) to understand how to connect the different ports to your existing wiring or power source.
3. If you are performing a wired installation, refer to the Wired Installation Diagram (Section 3) for guidance on how to connect the device to your doorbell system and power source using wires.
4. If you prefer a wireless installation, refer to the Wireless Installation Diagram (Section 4) for instructions on how to connect the device to your doorbell system and power source without using wires.
5. Before installing the device, mount the provided mounting plate on a flat surface or wall. Use a pencil to mark the four holes, then drill holes with a 6mm diameter and 30mm depth. Insert plastic wall plugs into the drilled holes (Section 5).
6. Align the Ingress Vision Smart Access Control + Video Camera with the top of the mounting plate and insert it until it reaches the bottom of the plate. Ensure that the device and video camera are completely tucked in. Secure the device with a xxxx at the bottom (Section 6).
Please note that for commercial use and professional installation, you can reach out to LOCKLY's support team at prosales@lockly.com or visit locklypro.com/support for further assistance.
Add New Comment