User Manual Q&AAnswer
Jan 16, 2025 - 05:00 AM
To install the PRG Series 400 7-Port Ethernet Switch, follow these steps:
1. If you are using a Series 400 rack chassis, install the Ethernet Switch in the top portion of the rack chassis. Make sure to leave enough space above the LED Meter Module.
2. At the rear panel of the Ethernet Switch, connect the AC Line Cord 208V PowerCon® Cable (supplied) to the Neutrik® connector.
3. After power is applied, verify that the ON indicator is lit.
4. At the front panel, connect the data cables as required. Refer to the "Connecting Ethernet Switch to System" section in the manual for more information.
Please note that these instructions are a general overview of the installation process. For more detailed instructions and illustrations, please refer to the PRG Series 400 7-Port Ethernet Switch User Manual.
Add New Comment