Answer
Jan 16, 2025 - 04:57 AM
To install the ANPVIZ SECURITY IPC-D240W-S Dome Camera, follow these steps:
1. Decide whether to run the cables through the OD along the ceiling. If running the cables along the ceiling, make sure to pass the cable through the cable notch on the camera base to keep it flush to the ceiling when mounted.
2. Use the included mounting template to mark holes for the mounting screws.
3. Connect the Ethernet cable to the camera as shown in the "Connecting the Camera" section.
4. If running the cables against the ceiling, pass the cable through the cable notch as shown.
5. Mount the camera to the ceiling using the included mounting screws.
6. If you need to adjust the viewing angle of the camera, twist the camera left and right to adjust the horizontal position. Loosen the adjustment xxxx on the side of the camera and tilt the camera to adjust its vertical position. Tighten the adjustment xxxx to lock the position.
7. Replace the cover and tighten the cover screws.
8. Remove the protective film from the dome cover.
For more detailed instructions and illustrations, please refer to the ANPVIZ SECURITY IPC-D240W-S Dome Camera Instruction Manual provided with the package.
Note: If you encounter any difficulties during installation or have further questions, you can contact ANPVIZ support via email at TechSupport@anpvizsecurity.com or visit their website at www.anpvizsecurity.com for additional support and information.
Add New Comment