How do I install the ORTECH OD-A2012W LED Landscape Deck Lights? (ORTECH OD-A2012W LED Deck Lights Instruction Manual)

Answer

manuals.plus

Jan 16, 2025 - 03:23 AM

To install the ORTECH OD-A2012W LED Landscape Deck Lights, please follow the steps below:

1. Turn off the power supply before starting the installation process.
2. Open the fixture by twisting the cap counterclockwise and pulling it away from the fixture. Note that the first time you do this, it may be difficult due to the tight O-ring seal.
3. Determine the desired location for each fixture and, if necessary, drill a wireway hole at this time. Hold the fixture with the gasket at the back in the correct direction, and secure it with screws.
- If installing on surfaces like brick or concrete walls, plastic anchors are required. Use the template provided in FIG.B to mark the location of the holes, and drill the holes for the plastic anchors using an appropriate drill bit. Place the plastic anchors in the holes. If necessary, drill the wireway hole at this time. Then, put the fixture with the gasket at the back in the desired location and secure it by screwing the two screws into the anchors through the holes on the fixture.
4. Strip the two leads from the fixture pigtail wire. Connect the leads from the fixture to the main low voltage supply cable leads.
5. Put back the cap and fix it by twisting it clockwise.

Please note that the installation of these lights should be carried out by a qualified electrician. It is important to follow the National Electric Code (NEC) and local code specifications. Additionally, always use UL, cUL, and CSA recognized wire connectors for connections and do not use extension cords on power units.

For further assistance or if you have any doubts about the installation or use of this product, it is recommended to consult a competent electrician.