How do I connect and power my devices using the TELTONIKA TSW100 Unmanaged PoE+ Switch? (TELTONIKA TSW100 Unmanaged PoE+ Switch User Guide)

Answer

manuals.plus

Jan 16, 2025 - 01:16 AM


To connect and power your devices using the TELTONIKA TSW100 Unmanaged PoE+ Switch, follow these steps:

1. Connect your main internet router/modem to the TSW100 LAN port number 5.
2. Connect the end devices (such as IP cameras) that you want to power via Ethernet to the TSW100 ports 1 to 4.
3. Plug the 4-pin power plug into the TSW100 to power up the switch.

Please note the following safety information and technical specifications:

- The TSW100 switch must be used in compliance with applicable national and international laws and any special restrictions regulating the utilization of the communication module in prescribed applications and environments.
- The switch is in compliance with the essential requirements and other relevant provisions of Directive 2014/30/EU and 2014/35/EU.
- The power adapter provided with the switch has an input of 1.8 A @100-240 VAC and an output of 48 VDC, 1.3 A, with a 4-pin plug.
- The switch has an input voltage range of 7 – 57 VDC and a maximum power consumption of less than 9 W when no PoE devices are connected.
- The maximum PoE power budget at PSE (Power Sourcing Equipment) is 120 W.
- The maximum Ethernet cable length supported is 100 meters.

For more detailed information and instructions, refer to the TELTONIKA TSW100 Unmanaged PoE+ Switch User Guide available at https://wiki.teltonika-networks.com/.