User Manual Q&AAnswer
Jan 16, 2025 - 12:47 AM
To pair the EVVR SRB02A In-Wall Relay Switch with your Zigbee 3.0 gateway, please follow these steps:
1. Make sure your Zigbee 3.0 gateway is in inclusion/pairing mode.
2. Short press the RESET button on the Smart Relay Lite.
3. The load light should be on, and the indicator light on the Smart Relay Lite will slowly flash BLUE.
4. Wait until the pairing is successful or until a 30-second timeout occurs.
5. If the Smart Relay Lite is successfully paired, the indicator light will show BLUE when the load light is on.
Note: If the pairing fails, it could be due to the device being too far from the gateway or routing device, or there may be interference in the current network environment. Try adding routing devices or bringing devices closer to the gateway/coordinator. If the device is already joined to another gateway, you will need to restore the device to its factory default before pairing it with a new gateway.
For more information or troubleshooting, please refer to the EVVR SRB02A In-Wall Relay Switch Instruction Manual.
Add New Comment