User Manual Q&AAnswer
Jan 16, 2025 - 12:02 AM
To install the QwikSEER WattSaver QT6000 90VAC to 240VAC Permanent-Split Capacitor, follow these steps:
1. Verify that you have a PSC blower motor. This product is only intended for use with PSC blower motors and should not be used with logic-controlled or speed-modulating blower motors.
2. Disconnect the power load before starting the installation process.
3. Find a suitable mounting location with sufficient clearance for the QwikSEER+ board. Use the supplied self-drilling sheet metal screws to attach the mounting bracket.
4. Move the common wire from the blower motor to the COM L1 terminal on the QwikSEER+ board. If the blower motor uses wires instead of spade terminals, use the supplied spade terminals to attach the wire to the board. Make sure to support the board when connecting wires to the terminals.
5. Move the remaining power lead from the blower motor to the COOL L2 terminal on the QwikSEER+ board. If the blower motor uses wires instead of spade terminals, use the supplied spade terminals to attach the wire to the board. If there are separate wires for heat and cool modes, only move the cool mode wire.
6. Use the supplied wires to connect the output terminals on the QwikSEER+ board to the corresponding common and speed terminals on the blower motor. If the blower motor uses wires instead of spade terminals, use the supplied wire nuts to splice the supplied wires to the blower wires. If there is a separate heat mode wire, use the supplied terminal splitter or wire nut to connect both the QwikSEER+ output wire and heat mode fan-speed wire. If the blower motor has more than three speeds, use the highest, lowest, and one of the mid-range speeds. If the motor has two speeds, connect both the medium- and low-speed wires from the QwikSEER+ board to the low-speed tap. Important: Do not jump the motor windings.
7. Attach the QwikSEER+ board to its mounting bracket. Align the board so that the side labeled "BRACKET SIDE" is adjacent to the bracket. Secure the board to the bracket using the supplied plastic clips. Press the clips through the bracket holes until they snap in place.
8. Connect the GND terminal on the QwikSEER+ board to a suitable chassis ground using the supplied ground wire and xxxx .
9. Attach the thermistor to an evaporator return bend near the coil inlet. Route the thermistor wire to the evaporator and use the supplied loop clamp to attach the thermistor to any return bend near the coil inlet. Secure the clamp using the supplied plastic ratchet rivet. For furnace systems, route the thermistor wire outside of the ignition chamber by drilling a 5/16" hole and using the supplied grommets.
10. If equipped with the , follow the QT6001 installation instructions to connect the sensor.
11. Bundle any excess wires using the supplied tie wraps to avoid interference with the blower.
12. Reconnect the power.
If you need further assistance, you can call 1-321-631-3550, view an online video installation tutorial at www.qwik.com/qwikseer/, scan the provided code, or chat with "Live Help" on their website at www.qwik.com/qwikseer/.
Add New Comment