User Manual Q&AAnswer
Jan 15, 2025 - 11:48 PM
To install the BURLEY SBS14W Square LED Bulkhead 14w in White Eurotech, please follow the installation instructions provided in the manual:
1. Remove the front diffuser from the base by removing the four diffuser fixing screws and pulling it away from the base tray.
2. Loosen the gear tray retaining screws, but do not remove them. Adjust the position of the gear tray to align the hole in the keyhole slots with the retaining screws. Remove the gear tray from the base.
3. Select a suitable cable entry point provided or drill a hole in the base.
4. Position and fix the base to a suitable solid surface using the screws provided. If using the knock out hole on the side, apply silicon to the joint or use an IP65 cable gland. Fit the grommet provided into the drilled hole to prevent damage to the cable. Feed the supply cable through the grommet.
5. Terminate the supply cable into the terminal block mounted on the underside of the gear tray, ensuring that the correct polarity is observed. All conductors must be fully sleeved and insulated.
6. Dress any cables away from the edges of the luminaire and re-align the gear tray. Refit the gear tray using the retaining screws.
7. Refit the front diffuser to the base using the four diffuser fixing screws.
8. Restore the mains power supply, switch on, and test for satisfactory operation.
Please note that all installations must be carried out by a qualified electrician following local regulations. Make sure to switch off the power before installation. It is also important to read and follow the safety instructions provided in the manual.
For any additional information or detailed specifications, you can visit the Eurotech Lighting website at eurotechlighting.co.nz.
Add New Comment