User Manual Q&AAnswer
Jan 15, 2025 - 11:09 PM
To connect your devices to the Pyle PCO875 Power Sequencer, follow these steps:
1. Identify the power requirements of your audio devices. Make sure the total power consumption of all your devices does not exceed the maximum power handling capacity of the power sequencer (e.g., 13 Amp 2000W).
2. Locate the AC INPUT on the back panel of the power sequencer. This is where you will connect the power cord of the sequencer to a power outlet.
3. Connect the power cord of the power sequencer to a suitable power outlet with the provided power cable.
4. Identify the 8 Sequence OUTLET ports labeled as CH 1 - CH 8 on the back panel of the power sequencer. These are the outlets where you will connect your audio devices.
5. Connect each audio device to the corresponding outlet on the power sequencer using standard power cords. Ensure that the power cords are securely plugged into both the device and the power sequencer.
6. For devices that require direct power without being controlled by the sequencer, use the 2 non-sequence outlets provided on the front panel of the power sequencer.
7. Once all your devices are connected, you can use the power sequencer's POWER ON/OFF switch on the front panel to turn them on or off simultaneously.
Note: It is important to follow the recommended power-up and power-down sequence to avoid any potential damage to your devices. Typically, you should turn on low-power equipment first and turn off high-power equipment first.
For more detailed information and illustrations, please refer to the Pyle PCO875 Professional 10-Channel Power Sequencer User Manual.
Add New Comment