User Manual Q&AAnswer
Jan 15, 2025 - 10:12 PM
To connect the Carlsbro CSD25M Electronic Drum Set to your computer for recording, you will need a USB cable and recording software. Here's how you can do it:
1. Connect the USB cable: Locate the USB port on the drum module and connect one end of the USB cable to it. Then, connect the other end of the USB cable to an available USB port on your computer.
2. Set up your recording software: Install and open your preferred recording software on your computer. Make sure it is compatible with MIDI input.
3. Configure the MIDI settings: In your recording software, navigate to the MIDI settings or preferences. Select the Carlsbro CSD25M as the MIDI input device. This will allow your computer to receive MIDI data from the drum module.
4. Select the drum sounds: In your recording software, create a new MIDI track and assign it to the Carlsbro CSD25M as the input source. This will ensure that the drum sounds from the electronic drum set are recorded.
5. Arm the track and start recording: Arm the MIDI track for recording in your software. When you're ready to start recording, press the record button and begin playing the electronic drum set. The MIDI data will be captured by the software, allowing you to edit and manipulate the drum sounds later.
6. Monitor the recording: If you want to monitor the recording in real-time, connect headphones or speakers to the headphone output of the drum module. This will allow you to hear the drum sounds while recording.
Note: The specific steps may vary depending on the recording software you are using. Refer to the software's user manual for detailed instructions on setting up MIDI recording.
By following these steps, you can connect the Carlsbro CSD25M Electronic Drum Set to your computer for recording and capture your drumming sessions with ease.
Add New Comment