User Manual Q&AAnswer
Jan 15, 2025 - 08:33 PM
To connect the Alesis Command Mesh Kit SE to your computer for recording or MIDI integration, you will need a USB cable (sold separately). Here are the steps to connect the drum kit to your computer:
1. Make sure your computer is turned on and running the appropriate music software (e.g., a digital audio workstation or MIDI software).
2. Locate the USB Type-B port on the rear panel of the drum module.
3. Connect one end of the USB cable to the USB Type-B port on the drum module.
4. Connect the other end of the USB cable to an available USB port on your computer.
5. Once the drum kit is connected to your computer, it should be recognized as a MIDI device by your music software.
6. Configure your music software to receive MIDI input from the drum kit. Refer to the software's documentation or user guide for instructions on how to set up MIDI input.
7. You can now use the Alesis Command Mesh Kit SE to trigger sounds in your music software or record your drumming directly into your computer.
Note: The USB connection is for MIDI information only and does not transmit audio. If you want to record the audio output of the drum kit, you will need to connect the audio outputs of the drum module to your computer's audio interface or recording device using appropriate audio cables.
Add New Comment