How do I install the GRUNDFOS SCALA1 Fully Integrated Compact Self Priming Pressure Booster? (GRUNDFOS SCALA1 Self Priming Pressure Booster Instruction Guide)

Answer

manuals.plus

Jan 15, 2025 - 08:29 PM


To install the GRUNDFOS SCALA1 Fully Integrated Compact Self Priming Pressure Booster, follow these steps:

1. Before starting any work, switch off the power supply and ensure it cannot be accidentally switched on.

2. Ensure that the product is only used for water and not for flammable or toxic liquids.

3. Mount the product horizontally to prevent condensation in the electrical insulation inside the control box.

4. If using the pump for supplying drinking water, flush the pump thoroughly with clean water to remove any impurities or contaminants.

5. Make sure that all electrical connections are carried out by qualified persons in accordance with local regulations. The protective earth (PE) of the power outlet must be connected to the protective earth of the pump.

6. If the power cable is damaged, it should be replaced by the manufacturer, the manufacturer's service partner, or a similarly qualified person.

7. If setting up a SCALA1 twin booster system or external input, follow the specific instructions provided in the manual.

8. After installation, switch on the power supply and check that the product is intact and not cracked. If the product was not drained before standstill or was exposed to frost, ensure it is in good condition.

For more detailed instructions and safety information, refer to the GRUNDFOS SCALA1 Fully Integrated Compact Self Priming Pressure Booster manual.