User Manual Q&AAnswer
Jan 15, 2025 - 05:34 AM
Sure! Here is a step-by-step installation guide for the LIGHT 65146A LED Side Light:
1. Before starting the installation, make sure the power supply is turned off to avoid any electrical accidents.
2. Carefully unpack the LIGHT 65146A LED Side Light and ensure that all the necessary components are included.
3. Choose a suitable location for the side light installation. Ensure that the surface is clean and free from any dust or debris.
4. Hold the side light against the desired location and mark the positions for the xxxx holes using a pencil or marker.
5. Drill pilot holes at the marked positions using an appropriate drill bit. Make sure the holes are slightly smaller than the screws provided with the side light.
6. Insert the screws into the pilot holes and partially tighten them, leaving enough space to hang the side light.
7. Connect the electrical wires of the side light to the corresponding wires in the electrical box. Follow the wiring diagram provided in the manual for proper connections. It is recommended to use wire connectors or terminal blocks for secure connections.
8. Carefully position the side light over the screws and align the holes on the back of the light with the screws.
9. Fully tighten the screws to secure the side light in place. Ensure that the light is level and properly aligned.
10. Once the side light is securely installed, turn on the power supply and test the light to ensure it is functioning correctly.
Remember, it is important to follow all safety precautions mentioned in the manual. If you are unsure about any step or if you are not experienced with electrical installations, it is recommended to seek the assistance of a professional electrician.
Add New Comment