User Manual Q&AAnswer
Jan 15, 2025 - 05:25 AM
To assemble and install the BRAYER BR4880 Electric Convector Heater, follow these steps:
1. Stand mode:
a. Turn over the unit body and match the openings on the feet with the corresponding openings in the bottom part of the unit body.
b. Fix the feet with the screws supplied with the unit.
c. Turn over the unit and place it on an even steady surface.
2. Wall mounting:
a. Before drilling holes in the wall, ensure there is no electrical wiring or other communications at the chosen location.
b. When mounting the unit on the wall, ensure a distance of at least 300 mm from all sides of the unit body to any objects.
c. Do not use the feet with the wheels when mounting the unit on the wall.
d. Mark the holes on the wall for the upper brackets.
e. Drill two 8 mm holes in the wall to the required depth.
f. Insert the dowels into the drilled holes and tighten the fixing screws so that the xxxx goes into the bracket.
g. Align the xxxx caps with the holes in the upper wall bracket, slide the unit to the left and lower it down, ensuring it hangs evenly.
h. Mark the places for drilling holes on the wall for the lower brackets.
i. Remove the unit from the wall.
j. Drill 8 mm holes in the wall to the required depth for the lower brackets.
k. Insert the dowels into the drilled holes.
l. Align the xxxx caps with the holes in the upper wall bracket, slide the unit to the left, and lower it down, ensuring it is fixed properly on the upper brackets.
m. Fix the lower brackets with two screws, ensuring the convection fan heater is fixed properly on the wall.
Please refer to the instruction manual for detailed diagrams and illustrations of the assembly and installation process.
Add New Comment