User Manual Q&AAnswer
Jan 15, 2025 - 04:40 AM
To connect the Danley SH-SM Series Front Fill Asymmetrical Horn to an amplifier, you will need to use the NL4 ("speak-on") connectors located on the rear panel of the horn. The NL4 connectors are wired in parallel for passive operation.
Here is the pinout for the NL4 connectors in passive mode:
1+ Positive Full Range
1- Negative Full Range
2+ Pass Through
2- Pass Through
To connect the horn to the amplifier, follow these steps:
1. Make sure the amplifier is turned off and unplugged from the power source.
2. Locate the NL4 connectors on the rear panel of the horn.
3. Connect the positive terminal of the amplifier to the 1+ NL4 connector on the horn.
4. Connect the negative terminal of the amplifier to the 1- NL4 connector on the horn.
5. If you are using multiple horns, you can daisy-chain them by connecting the 2+ and 2- NL4 connectors of one horn to the corresponding NL4 connectors of the next horn.
6. Once all connections are made, double-check that they are secure and properly connected.
7. Turn on the amplifier and adjust the volume as desired.
Please note that the instructions provided are for passive operation. If you want to use the horn in bi-amp mode, where you have separate amplifiers for the low frequency and mid/high frequency sections, refer to the manual for the specific pinout and wiring instructions.
It is important to follow the manufacturer's instructions and consult a professional if you are unsure about the proper setup and connection of the horn to ensure optimal performance and safety.
Add New Comment