Answer

Jan 15, 2025 - 04:36 AM
To install the SUNRICHER SR-DA9033A-MW IP65 DALI-2 Multi-Sensor with ZHAGA Interface Socket, please follow these steps:
1. Read the user manual carefully before installation to ensure proper understanding of the product and its features.
2. Determine the appropriate mounting location for the sensor. The sensor head has a diameter of 50mm and a height of 35mm, while the receptacle has a diameter of 30mm. The sensor should be mounted using an M20X1.5 thread with a thread length of 18.5mm.
3. Ensure that the wiring is done correctly according to the provided wiring diagram. If using non-D4i DALI drivers, make sure to connect the DALI wires of the sensor to the DALI power supply. If using D4i drivers that provide DALI power supply and AUX 24V power supply, ensure correct polarity when wiring the DALI wires of the sensor to the DALI power supply.
4. Once the sensor is properly mounted and wired, connect the sensor-equipped luminaires to the mains power.
5. The sensor is DALI-2 certified and can be easily configured through a DALI-2 compliant central control unit. Refer to the user manual for instructions on how to configure the sensor using the central control unit.
6. The sensor supports two instances: motion detector instance (303) for motion detection and light sensor instance (304) for light measurement. Each instance can be configured individually.
7. The sensor has an operating temperature range of -40℉ to 104℉ (-40℃ to 70℃) and an operating humidity range of 0-95% (non-condensing). It is also IP65 rated, making it suitable for outdoor use.
8. Ensure that power is not applied to the sensor during installation.
For more detailed information and specific configuration settings, please refer to the user manual provided with the product.
Add New Comment