User Manual Q&AAnswer
Jan 15, 2025 - 04:04 AM
To properly install the MISHIMOTO MMWS Borne Off-Road Wheel Spacers, follow these steps:
1. Start by removing the wheel from your vehicle.
2. Clean the mating surfaces of the hub and the wheel using a wire brush if necessary.
3. Place the wheel spacer on the hub, ensuring that it is fully seated and flush with the hub.
4. Use the provided lug nuts or lug bolts to fasten the wheel spacer to the hub. Turn them by hand first to avoid cross-threading, then snug them down with hand tools in a star pattern.
5. Use a torque wrench to tighten the wheel spacer fasteners to the manufacturer's recommended torque specification in a star pattern.
6. Install the wheel onto the wheel spacer, ensuring that the wheel is fully seated and flush with the spacer.
7. Secure the wheel with the original lug nuts or lug bolts. Turn them by hand first to avoid cross-threading, then snug them down with hand tools in a star pattern.
8. Use a torque wrench to tighten the wheel fasteners to the vehicle manufacturer's recommended torque specification in a star pattern. Do not exceed the recommended torque specification.
9. Go for a 3 to 5-mile test drive, making a few left and right turns. Then, remove the wheels and repeat step 5.
10. Repeat steps 6-8 to re-install the wheels.
11. Re-check the wheel lug nut or lug bolt torque after driving 25 miles.
Please note that these installation instructions are a summary and it is important to refer to the full installation guide provided by MISHIMOTO for complete and accurate instructions. If you need further assistance, you can reach out to MISHIMOTO's Customer Service Team at 1-877-GOMISHI.
Add New Comment