User Manual Q&AAnswer
Jan 15, 2025 - 02:25 AM
Before installing the interface, it is important to read the manual and have technical knowledge. Ensure that the place of installation is free of moisture and away from heat sources. The correct tools should be used during installation to avoid damage to the vehicle or product. Here are the steps to install the interface:
1. Remove and disconnect the factory stereo according to the vehicle owner's manual or consult a fitting professional.
2. Connect the 12 Pin connector from the stereo connection (patch) lead to the interface box.
3. Connect the opposite end of the stereo connection (patch) lead to the steering wheel control input on the back of the aftermarket stereo. Note: Consult the aftermarket stereo installation manual for further information on where to make the connection.
4. Connect the 14 Pin connector from the supplied wiring loom to the interface box.
5. Connect the 4 Pin camera extension harness to the interface box.
6. Connect the amplifier retention interface to the 8 Pin connector on the supplied wiring loom.
7. Remove the plastic dust cover from the amplifier retention interface and plug in the vehicle's fiber amplifier connection.
8. Connect the power/speaker ISO connector to the power/speaker ISO connector at the rear of the aftermarket stereo.
9. Connect flying wires from the main wiring harness to the head unit. Refer to the "Additional Connections" section in the manual for more information. Note that the Amp Remote and Reverse Gear wires must be connected for the interface to function correctly.
10. Connect the male red and white RCA connectors (speaker) to the front line outputs on the rear of the aftermarket stereo to retain vehicle amplifier audio.
11. Connect the male red and white RCA connectors (AUX) to the rear of the aftermarket stereo to retain the OEM AUX input.
12. Connect the male yellow RCA from the camera extension harness to the reverse camera input of the aftermarket head unit.
a) To retain functionality of the factory camera - connect the female yellow RCA from the camera extension harness to the male yellow RCA from the main wiring harness.
b) If fitting an aftermarket camera - connect the male yellow RCA from the aftermarket camera to the female yellow RCA from the camera extension harness.
13. Connect the USB retention harness to the vehicle and to the back of the aftermarket stereo to retain the OEM USB input.
14. Connect the quadlock connector on the supplied harness to the quadlock connector from the vehicle.
15. Test stereo and steering wheel control functionality for correct operation before reassembling the vehicle dashboard. If steering wheel control functions are unresponsive, uninstall the interface and wiring and reinstall carefully following the above steps.
Please note that this is a general overview of the installation process. For further help and support, it is recommended to contact the supplier directly or visit their support website for technical assistance.
Add New Comment