User Manual Q&AAnswer
Jan 15, 2025 - 12:31 AM
Sure! Here is a step-by-step guide on how to install the MeTra 95-6552B Dodge Charger 2015-Up kit:
1. Disconnect the negative battery terminal before starting the installation.
2. Use a panel removal tool to gently pry around the entire dashboard trim panel surrounding the radio display and instrument cluster. Unclip, unplug, and remove the dashboard trim panel.
3. Remove the four Phillips screws securing the radio display, disconnect the wiring, and then remove the display.
4. Pull out, unplug, and remove the climate control panel.
5. Use a cutting tool to remove the shaded area of the sub-dash to allow room for the aftermarket radio. Be careful not to cut into snap locations.
6. Attach the panel clips provided with the kit onto the new radio trim panel.
7. Attach the radio brackets to the radio using the screws supplied with the radio. The radio brackets should rest on the factory dash snap locations and place the radio in the correct location.
8. Place the radio and bracket assembly into the dash opening and test fit the radio trim panel. It is suggested to mark the holes and pre-drill with a 1/8" drill bit.
9. Reconnect the negative battery terminal and prepare for the Axxess interface installation.
10. Connect the wiring harnesses and antenna adapter included with the kit to the aftermarket radio.
11. Connect the Axxess interface to the wiring harnesses in the vehicle. The interface provides accessory power, retains audio controls on the steering wheel, retains safety chimes, and more.
12. Make the necessary wiring connections according to the instructions provided in the manual. Tape off and disregard any unused wires.
13. If you are retaining the factory backup camera, connect the 4-pin harness with yellow RCA jacks to the touchscreen display and the 6552 harnesses.
14. If you want to replace the factory Media hub with the LD-CHRYUSBAUX1 USB knockout replacement harness, follow the instructions provided in the manual.
15. Once all the connections are made, secure the touchscreen to the dash using the factory screws.
16. Connect the car side harness to the wiring harnesses in the vehicle.
17. Start the vehicle and program the kit by following the instructions provided in the manual. This process may take up to three minutes.
18. Test all functions of the installation for proper operation before reassembling the dash.
19. Secure the radio to the dash with the provided screws and snap the radio trim panel over the radio.
20. Reassemble the dash in reverse order of disassembly to complete the installation.
If you encounter any difficulties during the installation process, you can contact MeTra's Tech Support line at 386-257-1187 or via email at techsupport@metra-autosound.com. They are available to assist you during their tech support hours.
Add New Comment