How do I install the Ansell AFRLED M3 Freska LED 18W Emergency Pack? (Ansell AFRLED M3 Freska LED 18W Instruction Manual)

Answer

manuals.plus

Jan 14, 2025 - 11:42 PM

To install the Ansell AFRLED M3 Freska LED 18W Emergency Pack, please follow these steps:

1. Before installation, ensure that the mains supply to the luminaire/device is switched off and the circuit supply fuses are removed or the circuit breaker is turned off.
2. It is recommended to have a qualified electrical contractor carry out the installation in compliance with the current edition of the IEE Wiring Regulations.
3. Check and verify that the total load on the circuit, including the luminaire/device, does not exceed the rating of the circuit cable, fuse, or circuit breaker.
4. Make sure that all fixings and suspensions used during installation are suitable for the luminaire being installed.
5. Connect the AFRLED/M3/ST emergency pack to the AFRLED/ LED Downlight, replacing the existing LED driver by disconnecting the male/female connectors.
6. Ensure the installation location provides adequate distance from water pipes, electrical cables, ceiling joists, or any other structural obstacles.
7. Connect the battery leads to the Driver/Inverter pack.
8. Connect the incoming supply cable to the AFRLED/M3/ST, ensuring correct polarity is observed.
9. Drill a 25mm hole for the LED housing, located in close proximity to the Freska LED downlight.
10. Feed the LED indicator into the aperture and locate it inside the LED housing.
11. Feed the AFRLED/M3/ST emergency pack into the aperture and install the AFRLED/ LED Downlight.
12. Offer the LED Freska into the aperture.
13. Do not cover with thermal insulation and do not extend any cable connections.
14. One fixture per pack only.

Please note that these instructions are a summary and should be followed in conjunction with the complete instruction manual provided with the product.