User Manual Q&AAnswer
Jan 14, 2025 - 09:19 PM
To assemble the SEALEY YK20FAH.V3 20tonne Floor Type Air-Hydraulic Press, please follow the steps outlined in the manual:
1. Unpack the product and check for any damaged or missing parts. If there are any issues, contact your supplier immediately.
2. Lay out all the parts and assemblies before beginning assembly.
3. Attach one base section (21) to the left frame post (20) and lower cross member (26) using bolts (25), washers (22), lock washers (23), and nuts (24). Attach two diagonal supports (60) between the post and base section using the same hardware.
4. Attach the other base section (21) and the right frame post (20) to the lower cross member (26). Attach two diagonal supports (60) between the right post and base section using the same hardware.
5. Put the press frame in an upright position and attach one upper crossbeam (10) to the left and right posts (20) using bolts (9), washers (13), lock washers (12), and nuts (11).
6. Hook the under plate (7) onto the first crossbeam and slide the other crossbeam sideways through the other hooks until it is in position in front of the posts. Attach it to the posts with bolts (9), washers (13), lock washers (12), and nuts (11).
7. xxxx the upper round nut (6) onto the ram (3), insert the ram into the hole in the under plate (7), then xxxx the lower round nut (8) onto the ram and attach the serrated saddle (5) to the ram.
8. Place the two halves of the press bed frame (18) back to back. Move them apart until the space between them is the same as the length of the four spacers (28). Align each spacer with the holes in the bed halves and insert a bolt (27) through both frames and the spacer. Secure the four bolts using washers (14), lock washers (15), and nuts (16).
9. Insert bed frame pins (19) into the holes in the posts at the same level. Hold the assembled bed frame diagonally between the posts. Turn it horizontally so that the ends are in contact with the posts and lower it onto the pins.
10. Attach the pump and air motor assemblies to the right post using bolts (29) and washers (14). Ensure that the air motor is below the pump. Insert the pumping handle (48) into the handle bracket (38).
11. Connect the hydraulic hose fitting (57) to the connection nut (58) and assemble the pressure gauge (1) to the pressure gauge connection nut and nylon ring (59) (2) on the top of the ram (3).
12. Tighten all nuts, bolts, and screws.
Please refer to the manual for any additional information or clarification on the assembly process.
Add New Comment