User Manual Q&AAnswer
Jan 13, 2025 - 10:54 PM
To replace the battery in the TECJOE H10A Colorful Doodle Board Electronic Drawing Pad, please follow these steps:
1. Make sure to turn off the drawing pad before replacing the battery to avoid any potential damage.
2. Locate the battery compartment on the back of the drawing pad. It is usually secured with a small xxxx or latch.
3. Use a screwdriver or your fingers to remove the xxxx or open the latch, allowing access to the battery compartment.
4. Take note of the type of battery required for your specific model. It is typically a replaceable coin-cell battery.
5. Carefully remove the old battery from the compartment, ensuring you do not damage any other components.
6. Insert the new battery into the compartment, making sure it is properly aligned with the positive (+) and negative (-) terminals.
7. Secure the battery compartment by tightening the xxxx or closing the latch.
8. Turn on the drawing pad and check if the new battery is functioning correctly.
Note: Always follow the manufacturer's instructions provided in the user manual for specific battery replacement guidelines and precautions. If you are unsure or encounter any difficulties, it is recommended to contact the manufacturer's customer support for further assistance.
Add New Comment