User Manual Q&AAnswer
Jan 13, 2025 - 03:27 AM
To charge electronic devices using the FlexSolar E10 Lightweight Backpack Solar Charger, please follow these steps:
1. Unfold the solar panel under direct sunlight.
2. Connect the flexible solar charger to your electronic device using the power output cable provided. The cable should have a USB connector on one end and the appropriate connector for your device on the other end.
3. Once the connection is made, the charging signal will be shown on your electronic device, indicating that it is receiving power from the solar charger.
4. If the sunlight is not sufficient, you can connect the solar charger to a power bank for energy storage. This allows you to charge your devices even when there is no sunlight available.
It is important to note the following precautions:
- Make sure the solar panel is placed under direct sunlight for optimal charging efficiency.
- Do not disconnect the solar charger while it is charging your device.
- Avoid damaging or scratching the surface of the solar panel.
- If the panel surface is hot, do not clean it. Wait for it to cool down before cleaning.
- Clean the surface of the solar panel when needed using a soft sponge or cloth. You can use a mild, non-abrasive cleaning detergent if necessary.
- Do not immerse the solar panel in water, although it is designed to be waterproof (IP67 rating).
For more detailed information and instructions, please refer to the FlexSolar E10 Lightweight Backpack Solar Charger User Manual.
Add New Comment