Answer
Jan 13, 2025 - 01:16 AM
To activate the LED lights on the GTSBROS GTS-2 Rear LED Lights Bike Helmet, follow these steps:
1. Locate the switch or control button for the LED lights. The specific location may vary depending on the helmet's design, but it is typically located near the rear of the helmet.
2. Ensure that the lights are fully charged. If the lights require charging, connect the provided charging cable to the helmet's LED lights and a power source, such as a USB port. Allow the lights to charge until the battery is full.
3. Once the lights are charged, press the switch or control button to turn on the LED lights. Depending on the helmet's design, there may be multiple lighting modes available, such as steady or flashing. Press the switch or control button again to cycle through the different lighting modes and select the desired mode.
4. Confirm that the LED lights are illuminated and functioning properly before your ride. If the lights do not turn on, ensure that the switch or control button is in the "on" position and that the lights are fully charged.
Note: Refer to the user manual provided with the GTSBROS GTS-2 Rear LED Lights Bike Helmet for specific instructions and illustrations related to your helmet's LED lights.
Add New Comment