User Manual Q&AAnswer
Jan 13, 2025 - 12:35 AM
To install the RAVAK B570000001 SONATA Bath Handles, please follow the steps below:
1. Before installing the bathtub, mount the handle. It cannot be mounted afterwards.
2. Locate the pre-drilled openings on the center of the side part of the bathtub. There should be 2 x 2 openings (9mm in diameter) for the 2 parts of the handle.
3. Place the handle against the pre-drilled holes with the flat side up. Ensure that it follows the shape of the bathtub.
4. Check if the holes in the bathtub coincide with the holes in the handle. If not, you can slightly press the handle into the proper position.
5. Before final placement of the handle, apply a small amount of silicone on the outer side of the holes, under the washers.
6. Put the handle in place and tighten the M8 screws and washers from the underside of the bathtub. Tighten the screws normally, avoiding over-tightening as it may cause deformation of the handle.
Please note that this information is based on the provided instruction manual for the RAVAK B570000001 SONATA Bath Handles. For further assistance or clarification, you may contact RAVAK directly through their provided contact details.
Add New Comment