User Manual Q&AAnswer
Jan 13, 2025 - 12:08 AM
To remove the shipping bolts from the Whirlpool CET9100GQ stacked washer dryer, follow these steps:
1. Position the washer/dryer so that the rear is within approximately 3 feet (900 mm) of its final location.
2. Keep the washer/dryer in the upright position.
3. Using a 1/2" wrench, loosen each of the four shipping bolts on the rear panel.
4. Once each bolt is loose, move it to the center of the hole and completely pull out the bolt, including the plastic spacer.
5. Discard the bolts and spacers.
6. Close the bolt holes with the four transport bolt-hole plugs.
Please refer to the "Removing Shipping Bolts" section in the user guide for visual instructions and additional information.
Note: It is important to remove the shipping bolts before using the washer/dryer to prevent damage during operation.
Add New Comment