How do I install the IMMERGAS 3.023961 Wall-Hung Modular Condensing Boiler safety devices kit? (IMMERGAS 3.023961 Wall-Hung Boiler Instruction Guide)

Answer

manuals.plus

Jan 12, 2025 - 11:57 PM


To install the IMMERGAS 3.023961 Wall-Hung Modular Condensing Boiler safety devices kit, follow these steps:

1. Ensure that you have all the components listed in the kit. Refer to the kit components description section in the instruction manual to verify.

2. Connect the safety kit manifolds as shown in figure 2, ensuring that you interpose the gaskets provided.

3. Connect the wires of the thermostat (6) and the pressure switches (7 and 12) as shown in figure 4.

4. If you are assembling the INAIL safety devices kit on the left side, follow the installation instructions shown in figure 3.

5. Make the electrical connection of the pressure switches (7 and 12) and the safety thermostat (6) according to the diagram in figure 4.

Note: The IMMERGAS boilers have an IPX5D electric insulation rating and can be installed outdoors without additional protections. However, if installed outdoors, ensure that the relevant piping is insulated and the kit is protected from the elements.

It is important to note that the IMMERGAS boilers must be installed with their own original safety kits. The manufacturer declines all liability if the installer does not use the approved original kits or uses them improperly.

Before closing the system cut-off  xxxx  (34), make sure to switch off the boiler.

For more detailed instructions and diagrams, please refer to the IMMERGAS 3.023961 Wall-Hung Modular Condensing Boiler instruction manual.