How do I install the Knightsbridge PWL3 Curved Up and Down Plaster Wall Light? (Knightsbridge PWL3 Plaster Wall Light Instruction Manual)

Answer

manuals.plus

Jan 12, 2025 - 11:25 PM


To install the Knightsbridge PWL3 Curved Up and Down Plaster Wall Light, please follow these steps:

1. Ensure that you have read and understood the general instructions provided in the manual.
2. Before starting the installation, make sure to isolate the mains power.
3. Check the total load on the circuit to ensure it does not exceed the rating of the circuit cable, fuse, or circuit breaker.
4. Take note of the IP (Ingress Protection) rating of the luminaire to determine the appropriate installation location. This product is suitable for indoor use only.
5. As this product is Class I, it must be earthed.
6. Provide power to the desired installation point.
7. Use the mounting plate provided as a template to mark the location for the fixing holes. Ensure that there are no gas/water pipes or electrical cables in the vicinity.
8. Connect the luminaire to the mains supply, ensuring the correct polarity is observed. The Live wire is Brown (L), the Earth wire is Green/Yellow (E), and the Neutral wire is Blue (N).
9. Fix the mounting plate to the wall using the screws, wall plugs, and washers provided.
10. Insert a suitable G9 lamp into the luminaire.
11. Fix the body of the luminaire to the mounting plate.
12. Switch on the power and check for correct operation.

Please remember to consult a qualified electrician if you have any doubts or concerns during the installation process.