How do I install the Memphis Audio TLN65FE OEM Direct Fit Front Speaker Enclosures on my vehicle? (Memphis Audio TLN65FE OEM Speaker User Manual)

Answer

manuals.plus

Jan 12, 2025 - 10:15 PM

To install the Memphis Audio TLN65FE OEM Direct Fit Front Speaker Enclosures on your vehicle, follow these steps:

1. Remove the 11 trim clips and 2 Hex head screws along the lower side cover on the driver and passenger side.
2. With the outside panel removed, position the corresponding template provided in the manual. Scribe the 2 bolt hole locations and the wire hole in the center.
3. Remove the trim clip above the kick plate. This hole will be used to bolt the attached brackets to the vehicle on each side. Each side will use 1 M4 bolt, 1 M4 nut, and 2 M4 washers.
4. Remove the template after marking the locations on the panel. Drill the CENTER HOLE using a 3/4” bit and the OUTSIDE HOLES using a 1/4” bit.
5. Run the wire through the 3/4” CENTER HOLE. Use the remaining 4 - 6M bolts and washers to bolt the enclosures from the back of the panel.
6. Once the installation is complete, turn on the system and enjoy your new speakers.

For more detailed instructions and visuals, you can refer to the complete walk-through video available on the Memphis Audio website at www.memphiscaraudio.com/installation-...

Please note that these instructions are specifically designed for 2019 and newer Honda Talon models. If you have a different year or model machine, it is recommended to check with your authorized Memphis Audio dealer or contact Memphis Audio customer service at 800-489-2300 before attempting installation. Installing these speakers on any other vehicle may result in permanent damage.