User Manual Q&AAnswer
Jan 11, 2025 - 12:59 AM
To adjust the heat settings on the Warm Storm WST-HDE-FT1 Electric Blanket, please follow these steps:
1. Make sure the electric blanket is properly plugged into the electrical outlet and the controller is securely connected to the blanket.
2. Locate the digital controller(s) that came with your electric blanket. The controller(s) should have buttons and an LCD display.
3. Press the power button on the controller to turn on the blanket. The LCD display should light up.
4. Use the temperature adjustment buttons on the controller to increase or decrease the heat level. These buttons are typically labeled with "+" and "-" symbols or have arrows pointing up and down.
5. The LCD display should show the current temperature setting as you adjust it. Continue pressing the temperature adjustment buttons until you reach your desired heat level.
6. If your electric blanket has dual-zone control for individual temperature settings, make sure to adjust the heat settings for each zone separately. The controller(s) should have separate buttons or zones labeled for each side of the bed.
7. Once you have set the desired heat level, the electric blanket will start heating up. It may take a few minutes for the blanket to reach the selected temperature.
Note: If the controller is not responding or the heat settings are not changing, please ensure that the controller is properly plugged into the electrical outlet and securely connected to the blanket. If the issue persists, refer to the troubleshooting section in the user manual or contact the manufacturer's customer support for further assistance.
Add New Comment