User Manual Q&AAnswer
Jan 11, 2025 - 12:39 AM
To connect your Sharp Notevision M20X Digital Video Projector to your computer, follow these steps:
1. Make sure both the projector and your computer are turned off.
2. Locate the VGA or HDMI port on your computer. The VGA port is typically blue, while the HDMI port is rectangular and labeled "HDMI."
3. Connect one end of the VGA or HDMI cable to the corresponding port on your computer.
4. Locate the VGA or HDMI input port on the projector. It is usually labeled "Computer In" or "HDMI In."
5. Connect the other end of the VGA or HDMI cable to the input port on the projector.
6. Turn on your computer and then turn on the projector.
7. Use the projector's remote control or the control panel buttons to select the appropriate input source. For VGA connection, select "Computer" or "RGB." For HDMI connection, select "HDMI."
8. Your computer's display should now be projected onto the screen or surface connected to the projector.
Please note that depending on your computer's operating system and settings, you may need to adjust the display settings to ensure the correct resolution and aspect ratio for optimal projection. Refer to your computer's user manual for instructions on adjusting display settings.
For more detailed instructions and troubleshooting tips, please refer to the Sharp Notevision M20X Digital Video Projector Instruction Guide provided in the link you provided.
Add New Comment