User Manual Q&AAnswer
Jan 10, 2025 - 09:04 AM
To install and use the Pyle PCO885 PDU Surge Protector, please follow these steps:
1. Plug the Power Cord (included) into a standard grounded 120V outlet.
2. Connect your sensitive electronic equipment to the 16 Rear Panel Outlets (located on the back of the unit).
3. Turn the Outlet Power Switch (located on the front panel) to the "ON" position. A lit LED will indicate that conditioned power is being provided to the connected equipment.
4. The Power Conditioner has a maximum load rating of 15 amps (or 3600W at 120VAC). If you exceed this maximum load, the Circuit Breaker (located on the rear panel) will trip, cutting off power to all connected equipment. If this happens, reduce the load by unplugging one or more units from the power conditioner and push the circuit breaker to reset it.
Please refer to the Pyle PCO885 PDU Surge Protector User Guide for more detailed information and safety instructions.
Note: It's always a good idea to consult the user manual for specific instructions and safety precautions when installing and using any electrical device.
Add New Comment