User Manual Q&AAnswer
Jan 10, 2025 - 04:24 AM
To replace the batteries in the Homemory HMNHQDDS12 Electric Flameless Votive Candles, follow these steps:
1. Turn off the candles: Before replacing the batteries, make sure the candles are switched off to avoid any accidental activation.
2. Remove the base: Flip the candle upside down and locate the battery compartment on the bottom. Depending on the design, you may need to twist or slide the base to open it. Refer to the user manual for specific instructions on accessing the battery compartment.
3. Replace the batteries: Once the battery compartment is open, remove the old batteries and dispose of them properly. Insert new batteries of the same type (typically CR2450) into the compartment, ensuring they are correctly aligned with the positive and negative terminals.
4. Close the battery compartment: After inserting the new batteries, securely close the battery compartment by twisting or sliding the base back into place.
5. Test the candles: Flip the candles back to their upright position and switch them on to check if the new batteries are functioning properly. The candles should now illuminate with a warm white flickering light.
Note: It is recommended to use high-quality batteries for optimal performance and longer battery life. If you continue to experience issues with the candles not lighting up after replacing the batteries, refer to the troubleshooting section of the user manual or contact Homemory customer support for further assistance.
Add New Comment