User Manual Q&AAnswer
Jan 09, 2025 - 11:07 PM
To connect the Pioneer Elite SP-EC73 center channel speaker to your receiver, follow these steps:
1. Make sure your receiver is turned off before making any connections.
2. Identify the speaker terminals on the back of your receiver. They are usually labeled "Center" or "C" for the center channel.
3. Take the speaker wire and strip off about 1/2 inch of insulation from each end.
4. Insert the bare wire into the corresponding positive (+) and negative (-) terminals on the back of the speaker. The positive terminal is usually red or marked with a "+" symbol, and the negative terminal is usually black or marked with a "-" symbol.
5. Tighten the terminals to secure the wire in place. Make sure there are no loose strands of wire that could cause a short circuit.
6. Repeat the process for the other end of the speaker wire, connecting it to the corresponding terminals on the back of the Pioneer Elite SP-EC73 center channel speaker. Again, make sure the positive and negative terminals are matched correctly.
7. Once the connections are secure, turn on your receiver and follow the setup instructions in your receiver's manual to configure the speaker settings. Make sure to set the center channel speaker to "Small" in the receiver's menu to ensure proper bass management.
8. Test the speaker by playing audio through your system. Adjust the volume and balance settings as needed to achieve the desired sound.
For more detailed information and illustrations, refer to the user guide provided with the Pioneer Elite SP-EC73 center channel speaker.
Add New Comment