How do I install the Cerwin Vega H752 2-Way Coaxial Speakers in my car? (Cerwin Vega H752 2-Way Coaxial Speakers User Manual)

Answer

manuals.plus

Jan 08, 2025 - 10:09 PM

To install the Cerwin Vega H752 2-Way Coaxial Speakers in your car, follow these steps:

1. Select a location: If your vehicle has existing factory locations for speakers, it is recommended to replace them with the same size speakers. If there are no factory speaker locations, choose the best locations possible, ensuring equal distance from your ears for optimal sound quality.

2. Door mounting (if not using factory locations): Before cutting, remove the door panel and check for clearance in the intended installation area. Avoid cutting any structural metal support or braces. It is also recommended to use a sound deadening mat on the door "skin" for better sound quality.

3. Rear deck mounting: There are two primary methods for mounting speakers in the rear deck - top mounting and bottom mounting. Top mounting requires dropping the speakers in through the deck, while bottom mounting secures the speakers from underneath. Ensure a good seal around the frame for optimal performance.

4. Running new wiring: In most cases, you can use the factory supplied wiring for the speakers. However, if new wires need to be run, use precautions such as using a grommet when running wires through metal to prevent damage. Never run wire through bare metal to avoid damage to the source unit, amplifier, or speakers. Safety against short circuits is crucial.

5. Tweeter installation: When flush or surface mounting tweeters, ensure the desired location can accommodate the hole sizes and depth required. The tweeter can also be surface mounted atop the dash, door, or rear deck. Follow the provided instructions for mounting the tweeter and connecting the wires.

6. Crossover installation: Install the passive crossovers in a well-ventilated area, preferably behind the door panel if using factory wiring. Connect the input side labeled "AMP" to the amplifier's speaker output terminals, ensuring correct polarity. Connect the middle terminals labeled "MID" to the midrange speaker and the end terminals labeled "TWT" to the tweeter, observing correct polarity.

Please refer to the Cerwin Vega H752 2-Way Coaxial Speakers User Manual for more detailed instructions and illustrations on the installation process.