User Manual Q&AAnswer
Jan 08, 2025 - 12:30 AM
To mount the King Electric PGH2448-ETB Garage Heater on a wall or ceiling, follow these steps:
1. Locate a wood stud in the wall or joist in the ceiling where you want to mount the heater.
2. Use the holes in the bracket provided with the heater to mark two holes for drilling. Make sure the holes are drilled into the wood stud or joist.
3. Pre-drill two holes for screws.
4. Secure two 66mm screws to the wall, leaving 1/8" exposed. Make sure the screws are attached to a wood stud or joist.
5. Attach the bracket to the wall by inserting the screws through the keyholes on the bracket and pushing down to lock it in place.
6. Tighten the screws against the bracket to secure it.
Important: The heater must be attached to a joist with a minimum of two screws in opposing holes. Use appropriate fasteners, as the screws included are for installing in wood studs only and not intended for metal joists.
For more detailed instructions and illustrations, please refer to the "Installation Instructions" section of the operational guide for the King Electric PGH2448-ETB Garage Heater.
Add New Comment