How do I install the Cerwin Vega H735 5 HED Series Coaxial Car Speakers? (Cerwin Vega H735 5 HED Series Car Speakers User Manual)

Answer

manuals.plus

Jan 07, 2025 - 08:26 PM

The installation process for the Cerwin Vega H735 speakers is outlined in the user manual. Here are the steps to install the speakers:

1. Selecting a Location: If your vehicle has existing factory locations, it is recommended to replace them with the same size speaker. If there is no factory speaker location, choose the best locations possible, ensuring the speakers are equal distance from your ears for optimal sound quality.

2. Door Mounting: If not using factory locations, remove the door panel and check for clearance in the intended installation area. Avoid cutting any structural metal support or braces. It is recommended to use a sound deadening mat on the door "skin" for better sound quality.

3. Rear Deck Mounting: There are two primary methods for mounting speakers in the rear deck - top mounting and bottom mounting. Top mounting requires dropping the speakers through the deck, while bottom mounting secures the speakers from underneath. Ensure a good seal around the frame for optimal performance.

4. Running New Wiring: In most cases, you can use the factory supplied wiring. If new wires need to be run, use a grommet when running the wire through metal to prevent damage. Avoid running wire through bare metal to prevent damage to the source unit, amplifier, or speakers.

5. Tweeter Installation: When flush or surface mounting tweeters, ensure the desired location can accommodate the hole sizes and depth required. The tweeter can also be surface mounted atop the dash, door, or rear deck. Follow the provided instructions for mounting the tweeter and connecting the wires.

6. Crossover Installation: Install the passive crossovers in a well-ventilated area, preferably behind the door panel instead of inside the door itself. Connect the input side labeled "AMP" to the amplifier's speaker output terminals. Connect the middle terminals labeled "MID" to the midrange speaker and the end terminals labeled "TWT" to the tweeter. Ensure correct polarity when connecting the tweeter to its lead wires.

Please refer to the user manual for detailed instructions and illustrations on the installation process. If you have any further questions, it is recommended to contact your local authorized Cerwin Vega Mobile dealer or the Cerwin Vega Mobile Technical Support Department for assistance.