User Manual Q&AAnswer
Jan 07, 2025 - 05:59 AM
To connect the ACU-200 to the SeaTalkng backbone, you will need to use the supplied SeaTalkng spur cable. Here are the steps to connect the ACU-200:
1. Locate the SeaTalkng backbone on your vessel. This is typically a SeaTalkng T-piece or 5-way connector block.
2. Connect one end of the SeaTalkng spur cable to the SeaTalkng backbone. Ensure that the cable is securely connected.
3. Connect the other end of the SeaTalkng spur cable to the SeaTalkng connector on the ACU-200. The SeaTalkng connector is located on the ACU connector panel.
4. Ensure that the SeaTalkng power switch on the ACU-200 is set to the appropriate position. If you want the ACU-200 to supply power to the SeaTalkng backbone, set the switch to "ON". If you have a separate power feed for the SeaTalkng backbone, set the switch to "OFF".
5. Once the connections are made, ensure that all cables are properly secured and routed to prevent damage.
By following these steps, you will be able to connect the ACU-200 to the SeaTalkng backbone and integrate it into your autopilot system. For more detailed instructions and illustrations, please refer to the Raymarine ACU-200 Autopilot Actuator Control Unit User Guide.
Add New Comment