User Manual Q&AAnswer
Jan 07, 2025 - 03:52 AM
The installation process for Cerwin-Vega H7683 coaxial speakers is explained in detail in the instruction manual. Here are the steps you can follow:
1. Selecting a Location: Choose the best location for installing the speakers in your vehicle. If there are existing factory locations, it is recommended to replace them with the same size speakers. Mount the speakers at an equal distance from your ears for optimal sound quality.
2. Door Mounting (if not using factory locations): Prior to cutting, remove the panel from the door and check for clearance in the intended installation area. Avoid cutting any structural metal support or braces. It is also recommended to use a sound-deadening mat on the door "skin" for better sound.
3. Rear Deck Mounting: There are two primary methods for mounting speakers in the rear deck - top mounting and bottom mounting. Ensure a good seal around the frame for optimal performance.
4. Running New Wiring: In most cases, you can use the factory-supplied wiring. However, if new wires need to be run, use a grommet when running wires through metal to prevent damage. Avoid running wires through bare metal. Safety against short circuits is crucial.
5. Tweeter Installation: Depending on your preference, tweeters can be flush or surface mounted. Ensure the desired location can accommodate the hole sizes and depth required. Follow the provided instructions for mounting the tweeter and connecting the wires.
6. Crossover Installation: Install the passive crossovers in a well-ventilated area, preferably behind the door panel. Connect the input side labeled "AMP" to the amplifier's speaker output terminals. Connect the middle terminals labeled "MID" to the midrange speaker and the end terminals labeled "TWT" to the tweeter, observing correct polarity.
Please refer to the complete instruction manual for detailed installation instructions, including illustrations and diagrams, to ensure proper installation and optimal sound quality.
Add New Comment