User Manual Q&AAnswer
Jan 07, 2025 - 02:49 AM
To adjust the temperature of the hot water dispensed by the InSinkErator HC-ViewSN-SS Instant Hot & Cold Water Dispenser, follow these steps:
1. Locate the thermostat dial on the front of the water tank.
2. Slowly turn the dial clockwise to increase the temperature or counterclockwise to decrease the temperature.
3. After adjusting the thermostat, activate the faucet handle for 20 seconds to bring in fresh water to be heated at the new setting.
4. Allow 5-7 minutes for the water to reach the new temperature.
Please note that the factory temperature pre-set is approximately 200°F. Adjusting the thermostat allows you to customize the temperature to your preference. However, it is important to use caution when operating the hot water dispenser, as the water dispensed is near-boiling and can cause scalds or burns.
Add New Comment