User Manual Q&AAnswer
Jan 07, 2025 - 02:22 AM
To connect your speakers to the Dayton Audio APA150 amplifier, follow these steps:
1. Ensure that the amplifier is powered down.
2. Remove approximately 1/2" of insulation from your speaker cables' positive and negative conductors.
3. Loosen the speaker binding posts by turning the knobs counter-clockwise, exposing the wire insert hole.
4. Observing polarity, insert the conductors into their appropriate binding posts and tighten the knobs down, securing the conductors in place.
For stereo operation, connect your left speaker to the left speaker output and your right speaker to the right speaker output.
For bridged-mono operation, set the Mono/Stereo switch to the Mono position. Connect the positive conductor of your speaker cable to the top left binding post and the negative conductor to the bottom right binding post.
Make sure to observe proper polarity when connecting your speakers. Positive (+) should be connected to positive (+) and negative (-) to negative (-) to ensure correct audio reproduction.
For more detailed instructions and illustrations, please refer to the Dayton Audio APA150 user manual.
Add New Comment