User Manual Q&AAnswer
Jan 07, 2025 - 02:19 AM
To connect the Klipsch RP 500SA Dolby Atmos Surround Sound Speakers to your amplifier, you can use conventional speaker wire. Here are the steps:
1. Using 16-12 gauge speaker wire, connect the RED "positive" (+) terminal of the LEFT speaker to the RED "positive" (+) terminal of your amplifier's LEFT channel.
2. Connect the BLACK "negative" (-) terminal of the LEFT speaker to the BLACK "negative" (-) terminal of your amplifier's LEFT channel.
3. Repeat the above procedure for connecting all the remaining speakers to the appropriate amplifier channels.
4. Make sure that no bare wires from any of the connections touch any other terminals to avoid causing a short and damaging your equipment.
5. Reference Premiere speakers are equipped with dual binding posts. If you are using a single wire connection, the terminal connecting bar should remain in place. If you are using a bi-wire or bi-amp connection, the terminal connecting bar must be removed. Please refer to your receiver's manual for further instructions.
For more detailed information and illustrations, please refer to Figure 3 in the Klipsch RP 500SA Dolby Atmos Surround Sound Speakers user manual.
Add New Comment