User Manual Q&AAnswer
Jan 06, 2025 - 10:21 PM
To ensure accurate blood pressure measurements, it is important to properly wrap the cuff around your arm. Here are step-by-step instructions on how to do it:
1. Start by locating the metal-loop part on the cuff. This is used to hold and adjust the cuff's length.
2. Thread the nylon fastener end of the cuff through the metal loop and pull it through.
3. Slide the cuff onto your arm, positioning it so that the tube is aligned with your middle finger.
4. Wrap the cuff around your upper arm, making sure it is snug but not too tight. The bottom edge of the cuff should be about 1 inch above the bend of your elbow.
5. Pull the cuff so that the top and bottom edges are tightened evenly around your arm.
6. Secure the cuff in place by fastening the nylon fastener to the fabric loop on the cuff.
7. Make sure the cuff is positioned at heart level. You can rest your arm on a table or support it with a pillow to achieve the correct height.
8. Once the cuff is properly wrapped and positioned, you can start the blood pressure measurement by following the instructions in the user manual.
By following these steps, you can ensure that the cuff is correctly wrapped around your arm, allowing for accurate blood pressure measurements.
Add New Comment