User Manual Q&AAnswer
Jan 06, 2025 - 09:27 PM
To connect the Pyle PLRGSW64BK 6.5 Inch Slim Waterproof Subwoofer to your car or marine audio system, please follow these steps:
1. Cut the drywall: Ensure that you have enough space to install the subwoofer. Cut a hole in the drywall that is large enough to accommodate the subwoofer.
Note: Always allow at least one-half inch between a wall stud and the speaker cutout to ensure the locking tabs can swivel into place.
2. Connect the speaker wires to the speaker: Connect the speaker wires from your car or marine audio system to the corresponding terminals on the subwoofer. Make sure to match the positive (+) and negative (-) terminals correctly.
3. Secure the subwoofer: xxxx down each of the four Phillips head screws provided with the subwoofer. This will allow the locking tabs to swivel into place and secure the unit to the rear surface of the drywall.
4. Secure the grille: Put in the strips of adhesive provided with the subwoofer to secure the grille in place.
Once you have completed these steps, your Pyle PLRGSW64BK 6.5 Inch Slim Waterproof Subwoofer should be properly connected to your car or marine audio system. Please refer to the user manual for any additional information or troubleshooting tips.
Add New Comment